Summary

Franke Bridge Valve for Lever Handle Model - 133.0069.364 Compatible Hot Side Kitchen Tap Cartridge. If you have the version of the Franke Bridge tap that has a tradition cross-section head then you will need a different cartridge.

Franke Bridge Lever Tap Spares: Compatible Cartridge Information

Measurements:

Other information:

Franke Bridge Lever Tap Spares Buying Guide

Is this Franke Bridge Lever tap spare the correct cartridge for your tap?

• To know the answer to this question, you have to look at the measurements of this cartridge and compare it with the cartridge you need to replace.
• The measurements of the cartridge you have can be taken by using a tape measure or a ruler.
• You can get the spline count of the cartridge you have by using a pen to mark the start point and slowly begin counting the notches from there.
• Important: This is a “hot” cartridge Franke Bridge Lever tap spare which must be installed in the “cold” side of the tap. The reason for this is the “cold” side of this particular tap opens clockwise (and this “hot” cartridge opens clockwise).
• Important: The reverse of the point above goes for the “cold” side cartridge. The “cold” side cartridge fits in the “hot” side of the tap. The reason being is the “hot” side of this tap opens anti-clockwise (and the “cold” cartridge opens anti-clockwise).
• Greasing the O-ring of the replacement Franke Bridge Lever tap spare cartridge is crucial. This will help seal the cartridge properly in the valve. (Please scroll to the section below to see the plumbing grease we offer.)

We supply other Franke tap spares . These are in stock (unless stated otherwise).

+ Spare part purchases made on a weekday – until 3:00 PM – will be shipped out on the same day.

+ Should you have any queries about spares for kitchen taps, showers, saunas, and shower doors, please message us. We will gladly assist you in hunting for the correct spare needed.