Summary

Newteam Showerforce SP-081-0520 Thermostatic Cartridge for NT 904-T Shower Valve

If this cartridge is showing out of stock, please contact us.

Shower Repair Common Questions: Newteam Showerforce SP-081-0520 Thermostatic Cartridge (Spare part for: NT 904-T Thermostatic Mixer Shower)

The Newteam Showerforce SP-081-0520 thermostatic cartridge replacement has been discontinued. But the good news is the spare part is available here at Di Vapor. Please contact us if you have any questions about the NT 904-T shower part. Our spares experts are always ready to attend to your queries. Weekend messages will be responded to first on Monday.

Question: What are the indicators that the Newteam Showerforce SP-081-0520 thermostatic cartridge needs a replacement?

Answer: The Newteam Showerforce SP-081-0520 for 904-T shower valves needs a replacement if:

• there is difficulty in adjusting water temperature;
• water is stuck in one temperature;
• there are leaks around the temperature control handle or the shower head;
• water flow problems;
• or the shower valve is making a lot of noise when in use.

Question: The water is running cold after a few minutes of using the shower? Is this because of the Newteam Showerforce SP-081-0520 thermostatic cartridge?

Answer: It can be due to a broken SP-081-0520 Newteam Showerforce thermostatic cartridge. However, it can be helpful to check if the boiler is still igniting.

If the boiler is functioning properly, the problem might be because of the SP-081-0520 Newteam Showerforce thermostatic cartridge. The piston in the cartridge might be unable to retract properly which is one of the clues the cartridge has broken down.

NT 904-T Newteam Showerforce SP-081-0520 Fitting Guide

Before proceeding to install the Newteam Showerforce SP-081-0520 thermostatic cartridge for shower valve NT 904-T please make sure the hot and cold water supplies are completely isolated. The mains valve can be closed if the isolation valves cannot be found. The drain can also be covered to prevent screws and washers from accidentally rolling in it.

1. Pop out the indice cap of the 904-T temperature control handle. A flat blade screwdriver can be used to do this. Be careful when using the screwdriver to avoid scratching the chrome finish.

2. Unscrew the handle’s retaining screw and separate the handle from the shower valve.

3. Pull out the black plastic temperature limit stop ring. Remember where the stop is pointed. (The stop is the raised part on the face of the stop ring.) This part has to be returned in the same position during reassembly.

4. Unscrew the 734479 retaining nut using a spanner.

5. Use needle-nose pliers and remove the faulty shower temperature cartridge. The spring can detach so see to it that the spring is also removed.

6. Insert the replacement Newteam Showerforce SP-081-0520 thermostatic cartridge and screw the retaining nut to secure the cartridge in place.

7. Return the stop ring (see step 3), the handle, the retaining screw and the indice cap.

8. Open water supplies and check if the installation is a success.

Di Vapor stocks Newteam and Showerforce spare parts to help with shower valve repair.

Why should you buy your spares from Di Vapor?

+ We supply top quality spares at reasonable prices.

+ We provide fantastic customer care and support.

+ We despatch spares at warp speed!

All spares (including the Newteam Showerforce SP-081-0520) are despatched on the same business day for purchases made before 3:00 PM from Monday to Friday.