Magnetic Shower Door Channel Seal | 6mm Channel | Slide Push Fit | 195cm 2m

Summary

**Sold as individual seals (not two). A complete set will require an order of two seals.

• Seal fits into channels up to 6mm wide,
• Sold in 1.95 metre lengths,
• Can be cut using very sharp large scissors, junior hacksaw, secateurs, pruning scissors
• Easy to install
• Sold individually, therefore if you need a complete door solution you will need to order two of this magnetic seal which will create a perfect seal for the shower door.
• Can be used on any brand of shower (including those below), however please check your measurements before making the purchase.

Possibly compatible with some of the following shower and bathroom brands and suppliers:

• Matki
• Merlyn Industries
• Methven UK
• MX Group
• Norcros Group

This magnetic shower door channel seal spare part will fit a channel, or track, which is up to 6 millimeters wide. Available in 2 meters length, use this replacement shower door channel seal to keep moisture in the bathing space.

The gap between a sliding door panel and the shower door groove is sealed by the magnetic strip. Made from heavy-duty material and magnet, it can water-proof and steam-proof the gap of a shower enclosure.

This magnetic seal for shower channel / track is sold individually.

2171GA6-85 is the flat magnetic shower door seal spare part for the sliding panel.

If your shower door channel is slightly wider than 6mm, 2165GA6-2 is the replacement shower door magnetic seal for a 7mm channel.

Need assistance in determining the correct shower door channel seal?

• You can contact us before making a purchase.

Vertical Magnetic Shower Door Seal for Metal Channel Fitment Tips

Magnetic shower door channel seals are a convenient way for holding the shower door in place as you take a good warm shower. Here are a few installation pointers.

1. Cut the magnetic strip to the same length as that of your shower door. Use a pen to mark where the strip should be cut. A pair of large and sharp scissors or a small hacksaw can be used to cut through the seal.

2. Before installing the seal, rid the metal channel of dirt and soap scum.

3. Fitting the seal is easy. Just slide and push it into the metal channel of the shower and it’s ready to use.

4. In case the seal keeps on detaching from the furrow, strong glue or double-sided adhesive can be applied on the back of the magnetic strip. A weather-proof silicone sealant is another option to keep the magnetic seal in place and, at the same time, prevent mildew from growing.

In Summary:

• This magnetic strip is sold in 2-meter lengths.
• Measure the width of the metal channel to make sure you buy the right replacement seal before making a purchase.
• Use big and razor-sharp scissors or a small hacksaw to cut it to the appropriate length.
• Clean the door’s metal channel before installing.
• Use adhesive or weather-proof sealant if the strip won’t stay in place.