Showermate Standard 2.6 bar Twin pumps aredesigned to boost the incoming hot and cold water supply to ashower, bath, showermixer, or mixer tap. Suitable for positive headapplications only.
Suitable for domestic use only, ShowermateStandard pumps are suitable for installation intoopen vented hot and cold water systems.
Showermate Standard pumps require a flow ofjust 0.8 l/min through the outlet to start.
|Mechanical seal||EPDM / PTFE / Al. Oxide|
|Anti vibration feet|
|Dry run protection|
|Maximum head (closed valve)||2.6 bar|
|Performance @ 9 l/min||1.9 bar|
|Performance @ 18 l/min||1.3 bar|
|Maximum flow||36 l/min|
|Maximum static inlet pressure||13 metres|
|Maximum working pressure*||380 kPa (3.8 bar)|
|Maximum ambient air temperature||40 °C|
|Min / Max water temperature**||Min 4 °C / Max 65 °C|
|Flow switch sensitivity (approx)||0.8 l/min|
|Pump connections||G ¾ male|
|Connections||G ¾ female x 15 mm push-in|
200 mm long
Isolating valves on inlet hoses
|Type||Induction, auto-reset thermal trip|
|Duty rating||Continuous (S1) @ 9 l/min and above***|
|Power supply/phase/frequency||230 V a.c./ 1 / 50 Hz|
|Current (full load)||2.2 Amps|
|Power consumption||505 Watts|
|Fuse rating||5 Amps|
|Power cable (pre-wired)||1.5 metres|
|Height (excluding hoses)||179 mm|
|Weight (including fittings)||5.5 Kg|
* The maximum pressure that can be applied to the pump under anyinstallation conditions.
** A stored water temperature of 60 °C is considered sufficientto meet all normal requirements and will minimise deposition ofscale in hard water areas.
*** Both heads pumping 4.5 l/min and above.
Di Vapor accepts the following payments methods:
Di Vapor treats your privacy and security with the utmost importance. The payment systems used by Di Vapor are based on industry standards to ensure all payments are securely handled. In fact, we ensure the Di Vapor website is regularly checked to guarantee compliance to PCI security standards.